Table of Contents
Advertisement
CHAPTER 4 SERVICE PROCEDURE
The iR-M2 is shipped from the factory with a standard board configuration, as shown in
F04-201-03. If optional components have been installed, see the documentation that came
with the specific option kit.
To service components inside the chassis, position the iR-M2 so that it is
resting on its side and the components inside the chassis are facing up.
Memo
Mouse (not used)
Keyboard (not used)
USB ports (not used)
Serial port
(not used)
Monitor (not used)
Parallel port (not used)
10/100BaseT
Empty slot
Copier int. board
Empty slot (reserved
for Token Ring option)
Empty slot (reserved
for parallel port option)
Empty slot
Empty slot
Power switch
Power connector
F04-201-03 iR-M2 side view and back panel view
4-6
Slot 1 not used
Slot2
Slot3
Slot4
Slot5
Slot6
not used
Back panel view
Motherboard connectors:
PCI1—Copier interface board
PCI2—Empty (reserved for Token Ring option)
PCI3—Empty (reserved for parallel–in option)
PCI4—Empty
PCI5—Empty
PCI6—Not used
COPYRIGHT © 2002 CANON INC.
Motherboard
PCI1
PCI1
PCI2
PCI3
PCI4
PCI5
PCI6
Power supply
2000 2000 2000 2000
Hard disk drive
Side view
CD-ROM drive
NM-PDL REV.0 JULY 2002
Advertisement
Table of Contents
