Table of Contents
Advertisement
Precautions
Always observe the following general precautions when installing and servicing the iR-
M2:
1. Report any shipping damage.
If there is any evidence of shipping or handling damage to the packing boxes or their
contents, save the damaged boxes and parts, call the shipper immediately to file a claim,
and notify your authorized service/support center.
2. Never alter an existing network without permission.
The iR-M2 will probably be connected to an existing Local Area Network (LAN) based
on Ethernet hardware. The network is the link between the customer's computer, exist-
ing laser printers, and other prepress equipment. Never disturb the LAN by breaking or
making a network connection, altering termination, installing or removing networking
hardware or software, or shutting down networked devices without the knowledge and
express permission of the system or network administrator or the shop supervisor.
3. Never assign an IP address in iR-M2 Network Setup.
Only the network administrator should assign an IP address to a network device.
Assigning the iR-M2 an incorrect IP address may cause unpredictable errors on any or
all devices connected to the network.
4. Always disconnect power before opening the iR-M2.
5. Use care when handling parts of the iR-M2, as some edges on the unit may be sharp.
For example, be careful when:
• Accessing the CD-ROM drive (keep the drive door closed when not in use)
• Plugging in cables at the back of the unit
• Using the power switch to power on/off the unit
vi
COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
Advertisement
Table of Contents
