Sony VPL-X2000U Service Manual page 61

Adjusting the Picture
This section describes how to adjust the focus, size and vertical position of
the picture when the projector is installed on the floor. For twin/triple stack
installation, refer to the Installation Manual supplied with the SU-PJ2000
projector stand.
1
Press the PATTERN key on the Remote Commander or the control
panel to display the HATCH pattern.
2
Press the FOCUS key then the V or v key on the Remote Commander
or the control panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
3
Press the ZOOM key then the V or v key on the Remote Commander
or the control panel to adjust the picture size.
"ZOOM" appears on the screen during adjustment.
Note
If the optional VPLL-2075, VPLL-2014 or VPLL-2009 lens is
installed, you cannot adjust the zoom.
4
Press the FOCUS and arrow keys on the Remote Commander or the
control panel to adjust the focus again.
"FOCUS" appears on the screen during adjustment.
5
Press the SHIFT key then the arrow keys on the Remote Commander
or the control panel to adjust the vertical position of the picture.
"PICTURE SHIFT" appears on the screen during adjustment.
6
Press the PATTERN key again to clear the HATCH pattern.
Note
Do not look into the lens when the projector lamp is on.
48
(GB)
Using the Menu
The projector is equipped with an on-screen menu for
making various adjustments and settings.
Unadjustable items are not displayed in the menu.
To change the language used in the menu, see page
55 (GB).
1
Press the MENU key.
The menu display appears.
The menu presently selected is highlighted in
yellow.
PICTURE CTRL VIDEO
CONTRAST: 80
BRIGHT: 50
COLOR: 50
HUE: 50
SHARP: 50
D.PICTURE: OFF
COLOR TEMP: LOW
COLOR SYS: AUTO
DRC: HIGH
2
Use the V or v key to select a menu, then press the
b or the ENTER key.
The setting items of the selected menu are
displayed.
Setting items
Menus
SET SETTING INPUT-A
STATUS: ON
SPEAKER: ON
LANGUAGE: ENGLISH
INSTALLATION: FLOOR-FRONT
OFF
POWER SAVING:
SIRCS RECEIVER: FRONT&REAR
GROUP INDEX: 0 1
DEVICE INDEX: 0 1
3
Make setting or adjustment on an item.
For details on setting individual items, see the relevant
menu pages.
To erase the menu display
Press the MENU key. The menu display also
disappears automatically if no key is pressed for one
minute.
To reset settings that have been adjusted
Press the RESET key.
"Reset complete!" appears on the screen and the
settings appearing on the screen will be reset to their
factory preset values.
Items that can be reset are as follows:
CONTRAST, BRIGHT, COLOR, HUE, SHARP,
DOT PHASE, SIZE, SHIFT and BLANKING.
About the memory of the settings
The settings are automatically stored in the projector
memory.
49
(GB)