Sony VPL-X2000U Service Manual page 18

Projecting
When you input the signal from equipment connected to the PC-3000
signal interface switcher (not supplied), set the SWITCHER/VIDEO
MEMORY/INDEX select switch on the Remote Commander to the
SWITCHER position and press the number keys to select the input.
When multiple switchers are connected, press the SW NO/OFF/
GROUP key, then press the number keys to select the input.
Note
Press the SYS SET key when you make the system connections using
the PC-3000 switcher.
Note on the VPL-X2000E model
The optional IFB-X2000E is required for selecting VIDEO.
3
Press the PATTERN key on the Remote Commander or the control
panel to display the HATCH pattern.
4
Press the FOCUS key then the V or v key on the Remote Commander
or the control panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
5
Press the ZOOM key then the V or v key on the Remote Commander
or the control panel to adjust the picture size.
"ZOOM" appears on the screen during adjustment.
Note
If the optional VPLL-2075, VPLL-2014 or VPLL-2009 lens is
installed, you cannot adjust the zoom.
6
Press the FOCUS and arrow keys on the Remote Commander or the
control panel to adjust the focus again.
"FOCUS" appears on the screen during adjustment.
22
(GB)
7
Press the SHIFT key then the arrow keys on the Remote Commander
or the control panel to adjust the vertical position of the picture.
"PICTURE SHIFT" appears on the screen during adjustment.
8
Press the PATTERN key again to clear the HATCH pattern.
To
Adjust the volume
Cut off the sound
Cut off the picture
Note
Do not look into the lens when the projector lamp is on.
To turn off the power
1
Press the STANDBY key on the Remote Commander or the control
panel.
The ON indicator flashes in green and the cooling fan keeps running
for about six minutes to reduce the internal heat. The ON indicator
flashes quickly for 30 seconds. During this time, you will not be able
to turn the power back on. After about 30 seconds, you can turn on the
power with the ON key.
When the fan stops running, the STANDBY indicator lights in red.
Note
To extend the lamp life, do not turn off the power for at least 10
minutes after turning on the power.
Press
the VOLUME +/– keys.
the AUDIO MUTING key (also cuts off the signal output
from the AUDIO OUT jacks.)
To restore the sound, press the AUDIO MUTING key again
or press the VOLUME + key.
the PIC MUTING key.
To restore the picture, press the PIC MUTING key again.
23
(GB)