Sony VPL-X2000U Service Manual page 59

Connection Examples
Confirming the System Construction
After all the connections are complete, confirm that equipment of the
system is properly setup.
1
Connect the AC cords of all equipment to the AC outlets.
2
Press the SYS SET key on the Remote Commander.
You can also press the LIGHT and RESET keys simultaneously on the
control panel for the same effect.
Information on the system construction and the settings of the interface
boards, etc. are automatically confirmed. Then the message disappears.
Note
When you want to use the projector without connecting the switcher after
using the switcher in the system connections, it is necessary to confirm the
system construction again by pressing the SYS SET key or the LIGHT and
RESET keys after all the connections are complete. If you press the key(s),
"Master Switcher not exist" appears, but the system construction is
automatically recognized.
When a system error is detected
The following messages are displayed on the screen and display window:
Message
Master Switcher not exist.
Same DEVICE INDEX for Projector
detected.
Same DEVICE INDEX for Switcher
detected.
Note
If the switcher is in standby mode, the message appears only in the
message display window.
44
(GB)
Remedy
Set the switcher that outputs the signal to
the projector to number 1.
Change either number of the projectors
that have the same number.
Change either number of the switchers
that have the same number.
Setting the Index Numbers
When you connect multiple projectors in your system, you have to set the
group index and device index numbers for each projector.
To set the group index number
If you set the same group index number for multiple projectors, you can
operate multiple projectors and switchers simultaneously (such as input
selection) by designating the number.
The group index number can be set in the menu.
For group index number setting, see page 56 (GB).
To set the device index number
If you set the device index number, you can control each projector
individually with the supplied Remote Commander.
The device index number can be set with the DEVICE INDEX switches on
the rear of the projector. It is set to "01" at the factory.
If only one projector is connected, set it to "01."
Notes
• Do not set the same device index number for the projectors in the same
system.
• Do not set the number to "00." If you do, the projector will be operated
only with the keys on the control panel. It cannot be controlled with the
wired or wireless Remote Commander, or with an external equipment to
which the PJ COM connectors are connected.
Ten's digit Unit's digit
0
45
(GB)