Sony VPL-X2000U Service Manual page 57

Connection Examples
Connecting the Switcher
Use the optional PC-3000 Signal Interface Switcher
for connecting various video equipment. The input can
be selected by pressing the SWITCHER/VIDEO
MEMORY/INDEX keys on the Remote Commander.
For selecting the input from the switcher, see page 17 (GB).
Notes
• When you select the input from the switcher, be sure
to set the SWITCHER/VIDEO MEMORY/INDEX
select switch to the SWITCHER position.
To connect a single switcher
Rear
INPUT C INPUT B INPUT A VIDEO
+
–
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
0
to INPUT A
to PJ COM IN
SIC-10 connecting cable
(5BNC ˜ 5BNC)
(not supplied)
to OUTPUT
PC-3000 switcher
Computer, etc.
40
(GB)
• When connecting the switcher, use the wired Remote
Commander. If you use the wireless Remote
Commander, activate the remote control detector on
only one unit of the equipment connected through the
PJ COM connector. For the other equipment, set
SIRCS RECEIVER in the SET SETTING menu to
OFF to deactivate the remote control detectors.
For details, see page 56 (GB).
• After all the connections are complete, attach the
terminator (supplied) to the PJ COM connector on
both the projector and switcher to which nothing is
connected.
Device index number: 01
AC power cord
(supplied)
to the wall outlet
to AC IN
Attach the
supplied
RCC-5G/10G/30G
terminator.
connecting cable
(not supplied)
to PJ COM OUT
Attach the
OUT PUT
terminator
SW NO RS-232C/422A
RS-232C REMOTE
RS-422A RS-485 IN (supplied with
RS-485 OUT
the PC-3000).
VCR, etc.
: Signal flow
To connect two switchers
Notes
• Set the device index number of the projector to be
connected to the switcher to 01.
Rear
INPUT C INPUT B
INPUT A VIDEO
+
–
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
0
RCC-5G/10G/30G
connecting cable
(not supplied)
SIC-10 connecting cable
(5BNC ˜ 5BNC)
(not supplied)
PC-3000 switcher
SW NO switch: 1
IFB-12A IN/OUT switch: IN
to IFB-12A
installed in
the switcher
SIC-10 connecting cable
(5BNC ˜ 5BNC)
(not supplied)
PC-3000 switcher:
to OUTPUT
SW NO switch: 2
OUT PUT
: Signal flow
• Set the SW NO switch on the switcher to be
connected to the projector to 1. Install the IFB-12A
interface board onto the switcher, and set the IN/OUT
switch on the IFB-12A to IN.
Device index number: 01
to the wall outlet
AC power cord
to AC IN
(supplied)
Attach the
supplied
terminator.
to OUTPUT
SW NO.
2 3 4
1 5
8 6
7
OUT PUT to PJ COM OUT
SW NO RS-232C/422A
RS-232C REMOTE
RS-422A RS-485 IN
RS-485 OUT
Computer
to PJ COM IN
RCC-5G/10G/30G
connecting cable (not
supplied)
SW NO.
2 3 4
1 5
8 6
7
Attach the
terminator
SW NO RS-232C/422A
RS-232C (supplied with
REMOTE
RS-422A RS-485 IN
the PC-3000).
RS-485 OUT
to PJ COM OUT
Computer
41
(GB)