Sony VPL-X2000U Service Manual page 17

Connecting with a Computer or a VCR
This section describes how to connect the projector with a computer, VCR,
and external active speakers. For details on how to connect other
equipment, see pages 42 (GB) to 44 (GB).
Also refer to the instruction manuals of the equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out by
the plug, not the cable itself.
Note on the VPL-X2000E model
The optional IFB-X2000E interface board is required for using the VIDEO
connectors.
VCR
to
to S VIDEO OUT
VIDEO
OUT
S video cable
(not supplied)
Rear
INPUT C INPUT B INPUT A VIDEO
AUDIO OUT
REMOTE
SMF-400 Monitor cable
(5BNC˜HD D-sub 15-pin)
(not supplied)
Audio cable
Use the optional ADP-20
(not supplied)
Signal adapter when
connecting with a Macintosh
computer.
Computer
Note
Set INPUT-A in the SIGNAL SELECT menu to RGB.
For details, see page 32 (GB).
20
(GB)
to AUDIO OUT
Video cable (not supplied)
Audio cable
(not supplied)
+
–
to a wall outlet
CONTROL S TRIG DEVICE INDEX
0
AC power cord
(supplied)
to AC IN
Audio cable
(not supplied)
Active speakers
Signal flow
:
Projecting
2
INPUT C INPUT B INPUT A VIDEO
+
–
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
0 0
7
5
3,8
2
2
2
1
Press the ON key on the Remote Commander or the control panel.
The ON indicator lights in green.
2
Turn on the power of equipment connected to the projector. Press the
INPUT SELECT keys on the Remote Commander or the control panel
to select the input source.
VIDEO: Selects the video signal input from the VIDEO or S VIDEO
connectors and the audio signal input from the AUDIO IN L/R
jacks. To switch the VIDEO or S VIDEO connectors, use the
SELECT key.
SELECT: Each time you press this key, the input signal is switched
between VIDEO and S VIDEO.
INPUT A: Selects the audio and video signals input from the INPUT
A connectors.
INPUT B: Selects the signal input from the connectors on the optional
interface board which is installed in the INPUT B section.
INPUT C: Selects the signal input from the connectors on the optional
interface board which is installed in the INPUT C section.
STANDBY indicator
Rear remote control detector
ON indicator
1
LIGHT ON
+ RESET SYS SET STANDBY
MENU
MUTING 4,5,6,7
PIC AUDIO APA
7
INPUT SELECT
+
VIDEO SELECT RESET ENTER
VOLUME
4,6
INPUT A INPUT B INPUT C – PATTERN ZOOM SHIFT FOCUS
POWER SAVING LAMP FAIL
5
COVER FAIL
1 2
FAN FAIL
3 4
3,8
HIGHT TEMP
4,6
LIGHT
MUTING STATUS COMMAND 1
PIC AUDIO OFF ON OFF ON STANDBY ON
RGB CENT
NORMAL APA DOT PHASE SIZE SHIFT R MEMORY MENU
LCD LENS CONTROL 4,5,6,7
PATTERN ZOOM SHIFT FOCUS B
INPUT SELECT
ENTER
VIDEO SELECT SYS SET BLKG RESET PUNCTION
VIDEO/S VIDEO
PICTURE CONTROL
A B C D BRIGHT CONTR POSITION
SWITCHER/VIDEO MEMORY /INDEX NO
1 2 3 4
5 6 7 8 SHARP HUE COLOR VOLUME
SW NO/
VIDEO MEMORY
9 10/0(ALL) OFF/GBOUP SWITCHER INDEX
(Continued)
21
(GB)