Monitoring And Maintaining Fallback Bridging - Cisco Catalyst 3750-X Software Configuration Manual

Monitoring and Maintaining Fallback Bridging

Command
Step 5
show running-config
Step 6
copy running-config startup-config
To re-enable spanning tree on the port, use the no bridge-group bridge-group spanning-disabled
interface configuration command.
This example shows how to disable spanning tree on a port in bridge group 10:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# bridge group 10 spanning-disabled
Monitoring and Maintaining Fallback Bridging
Table 50-2 Commands for Monitoring and Maintaining Fallback Bridging
Command
clear bridge bridge-group
show bridge [bridge-group] group
show bridge [bridge-group] [interface-id |
mac-address | verbose]
To display the bridge-group MAC address table on a stack member, start a session from the stack master
to the stack member by using the session stack-member-number global configuration command. Enter
the show bridge [bridge-group] [interface-id | mac-address | verbose] privileged EXEC command at the
stack member prompt.
For information about the fields in these displays, see the Cisco IOS Bridging and IBM Networking
Command Reference, Volume 1 of 2, Release 12.2.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
50-10
Purpose
Verify your entry.
(Optional) Save your entry in the configuration file.
Purpose
Removes any learned entries from the forwarding database.
Displays details about the bridge group.
Displays MAC addresses learned in the bridge group.
Chapter 50 Configuring Fallback Bridging
OL-21521-01