Turning Off The Sleep Timer; Setting The Sleep Timer - Kyocera FS-6020 Operation Manual
Page printer
Hide thumbs
Also See for FS-6020:
- Service manual (164 pages) ,
- Installation manual (28 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
Press the ENTER key. A blinking cursor (_) appears.
5
>Form Feed
Time Out 000sec.
Press the
or
6
ue of the figure where the cursor is blinking and set
the desired time. The time can be set between 0 and
495 seconds, in 5-second increments. (The printer
does not timeout with the value set to 0.) You can
use the
and
left.
Display the desired time and press the ENTER key.
7
Press the MENU key. The message display returns to
8
Ready.
Turning Off the Sleep Timer
You can turn off the sleep timer function by following the
procedure given below.
Press the MENU key.
1
Press the
or
2
pears.
Others
Press the
key.
3
Press the
or
4
Timer > appears.
>Sleep timer
015 min.
Press the
key and display >>Sleep Mode.
5
>>Sleep Mode
On
Press the ENTER key. A blinking question mark (?)
6
appears.
>>Sleep Mode
? On
1-54
key to increase or decrease the val-
keys to move the cursor right and
key repeatedly until Others > ap-
>
key repeatedly until >Sleep
>
Select Off using the
7
>>Sleep Mode
? Off
Press the ENTER key.
8
Press the MENU key. The message display returns to
9
Ready.
Setting the Sleep Timer
The printer has a sleep timer to conserve power when the
printer is not printing, processing, or receiving data. You can
adjust the timer value, the length of time the printer waits
before entering sleep mode in the absence of data.
NOTE
The default setting of the sleep mode is On (enabled).
Press the MENU key.
1
Press the
or
2
pears.
Others
Press the
key.
3
Press the
or
4
Timer > appears. The default setting is 015 min.
>Sleep Timer
015 min.
Press the ENTER key. A blinking cursor ( _ ) ap-
5
pears.
>Sleep Timer
015 min.
Press the
or
6
ue of the figure where the cursor is blinking and set
the desired time. The timer can be set between 5 and
240 min, in 5-minute increments. You can use the
and
keys to move the cursor right and left.
Press the ENTER key.
7
Press the MENU key. The message display returns to
8
Ready.
or
key.
key repeatedly until Others > ap-
>
key repeatedly until >Sleep
>
>
key to increase or decrease the val-
Advertisement
Table of Contents
