Setting The Character Pitch For Courier/Letter Gothic; Setting The Code Set - Kyocera FS-6020 Operation Manual

Setting the Character Pitch for Courier/Letter
Gothic
You can set the character pitch for fixed-pitch fonts when the
default font is Courier or Letter Gothic.
Press the MENU key.
1
Press the or
2
pears.
Font
Press the key.
3
Check that Internal is displayed and press the
4
key.
>Font Select
Internal
Press the or
5
pears.
> Pitch
>
10.00 cpi
Press the ENTER key. A blinking cursor ( _ ) ap-
6
pears.
> Pitch
>
10.00 cpi
Press the or
7
ue of the figure where the cursor is blinking. The
character pitch can be set between 0.44 and 99.99
characters per inch, in 0.01 character-per-inch incre-
ments. You can use the
cursor right and left.
When the desired size is displayed, press the ENTER
8
key.
Press the MENU key. The message display returns to
9
Ready.
key repeatedly until Font > ap-
>
>
key repeatedly until >>Pitch ap-
key to increase or decrease the val-
and keys to move the
Chapter 1 Using the Operator Panel

Setting the Code Set

You can change the character code set. Available character
code sets vary depending on the current font. (The default is
IBM PC-8.)
Press the MENU key.
1
Press the or
2
pears.
Font
Press the key.
3
Press the or
4
appears.
>Code Set
IBM PC-8
Press the ENTER key. A blinking question mark (?)
5
appears.
>Code Set
?IBM PC-8
Press the or
6
code set appears.
Press the ENTER key.
7
Press the MENU key. The message display returns to
8
Ready.
key repeatedly until Font > ap-
>
key repeatedly until >Code Set
key until the desired character
1-29