Removing Dimms; Testing The Expansion Memory; Setting The Printer Driver - Kyocera FS-6020 Operation Manual

Chapter 6 Option Units
Close the stoppers of the DIMM socket to secure the
5
DIMM.
When you finish installing the DIMM, reinsert the
6
side cover into the printer by reversing the removal
procedure.

Removing DIMMs

To remove a DIMM, carefully pull the end stoppers out-
wards, then pull the DIMM out of the socket.
6-4

Testing the Expansion Memory

After you finish installing DIMMs in the printer, test the
printer to see if the installation was successful. To test the
expansion memory, proceed as follows:
Make sure printer is turned off. Plug the power cord
1
into the printer and turn the printer on.
Press the MENU key on the operator panel.
2
Press the or
3
Status Page appears.
Press the ENTER key twice.
4
If the installation was successful, the amount of
5
memory shown on the status page will correspond
with the amount of expanded memory. (The factory
installed memory size is 16 MB.)

Setting the Printer Driver

After you install the additional memory to the printer, follow
the instructions below to set the printer driver so that the
printer can use the memories efficiently.
Click the Windows Start button, point to Settings
1
then click Printers.
Right click the Kyocera Mita FS-6020 KX icon, and
2
click Properties.
The Properties dialog box will open. Click the Device
Settings tab.
Enter the total memory size installed to the printer
3
(up to 144 MB) in the Memory box.
key repeatedly until Print