PF-400 Paper Feeder
PF-400 Paper Feeder can be installed below the printer.
For details of installing the optional paper feeder in the
PF-400 Operation Guide
printer, see the
DU-400 Duplexer
DU-400 Duplexer can be installed to rear of the printer.
For details of installing the optional duplexer in the printer,
DU-400 Operation Guide
see the
Network Interface Card
Option network interface card is installed in the option inter-
face slot located at the rear of the printer. Take the following
steps to install option network interface cards. And also see
the documentation included with the option.
NOTE
• The network interface card should be installed only by a
Kyocera Mita authorized dealer or Kyocera Mita certified tech-
nician. Kyocera Mita shall not be liable for damage due to im-
proper installation of the network interface card.
• The following instructions are intended for the technician only.
Turn off the printer and disconnect the power cord
1
and printer cable.
.
.
Remove the screws from the printer's option inter-
2
face slot cover to remove the cover.
Insert the network interface card and secure it with
3
the screws removed in step 2.
Connect the network cable. Then, re-connect the
4
power cord to the outlet and the printer cable.
Turn on the printer and then set the network address
5
from the printer operator panel (for details about the
modes, see
Changing Option Network Interface
Parameters on page 1-44
Chapter 6 Option Units
).
6-5