Printing The Service Status Page - Kyocera FS-6020 Operation Manual

NOTE
• Items and values on the status page may vary depending on
the printer's firmware version.
• The network status page will also be printed after the status
page if the option network interface card is installed. For de-
Printing the Option Network Status Page on
tails, see
page 1-12
.
1
Software Version
This information shows the firmware version and date of
issue of the printer.
2
Hardware Information
This information shows various printer settings, such as
the size and type of the paper in the paper cassettes.
3
Memory
This shows the amount of the total memory installed in
the printer, the amount of currently available memory,
and the current status of the RAM disk. See
RAM Disk on page 1-50
4
Page Information
This shows the print resolution, the number of copies,
and the total page count.
5
Installed Options
This shows the option(s) installed in the printer.
6
Network Status
This shows the IP address, Subnet Mask address, and
Default Gateway address for the network interface.
7
Emulation
This shows all available emulations of the printer. The
printer is shipped from the factory with the PCL 6 emu-
lation selected as the default.
8
Error Log
This shows the last three instances of the following types
of errors, listing them in the order of their occurrence:
KPDL errors; memory related errors; or memory card re-
lated errors. The most recent error is displayed on the
top line of the Error Log. For error remedies, see
Maintenance Messages on page 4-4
tion is cleared when the printer's power is turned off.
9
Toner Gauge
This shows the approximate level of the remaining toner.
When the value is 100, the toner container is full.
10 Interface Information
This information shows the default font and the default
emulation for all interfaces installed in the printer.
11 KIR Test Pattern
KIR is the Kyocera's original smoothing function. This
test pattern shows the effect of the KIR (Kyocera Image
Refinement) system.
Using the
.
. The error informa-
Chapter 1 Using the Operator Panel

Printing the Service Status Page

The service status page contains printer settings information
that is more detailed than the standard status page and is
therefore for mostly service purposes. To print a service sta-
tus page, proceed as follows;
Press the MENU key.
1
Press the or
2
pears.
Others
Press the key.
3
Press the or
4
appears.
>Service
Press the key.
5
Press the or
6
Status Page appears.
>>Print
Status Page
Press the ENTER key. A question mark (?) appears.
7
>>Print
Status Page ?
Press the ENTER key. The message display indicates
8
Processing and printing starts. When printing is
completed, the message display returns to Ready.
key repeatedly until Others > ap-
>
key repeatedly until >Service >
>
key repeatedly until >>Print
1-11