Pagenation; Changing The Emulation; Kc-Gl Pen Width - Kyocera FS-6020 Operation Manual

Pagenation

This section explains the following topics regarding the pa-
genation that can be set form the operator panel:

•Changing the Emulation

•Setting the Default Font
•Setting the Code Set
•Setting the Number of Copies
•Selecting the Reduced Print
•Selecting the Printing Orientation
•Setting the KIR Mode
•Setting the EcoPrint
•Setting the Resolution
Changing the Emulation
The emulation mode for the current interface can be changed.
Press the MENU key.
1
Press the or
2
appears. One of the emulation names shown below
appears, indicating the current emulation.
PCL 6 (default)
KC-GL
KPDL
KPDL (AUTO)
Line Printer
IBM Proprinter
DIABLO 630
Epson LQ-850
Press the ENTER key. A blinking question mark (?)
3
appears.
Emulation
?PCL 6
Press the or
4
emulation mode appears.
Press the ENTER key. The
5
sub-menu >Code Set.
Press the MENU key. The message display returns to
6
Ready.
After changing the emulation, you have the option to
change the character code set. Available character
code sets vary depending on the current emulation.

KC-GL Pen Width

The KC-GL emulation mode enables you to set the pen
widths in dots, for pen numbers 1 to 8, and the KC-GL page
size.
key repeatedly until Emulation
key repeatedly until the desired
key allows access to
Chapter 1 Using the Operator Panel
Press the MENU key.
1
Press the or
2
appears on the message display.
Emulation
PCL 6
If the current emulation is other than KC-GL, press
3
the ENTER key. A blinking question mark (?) ap-
pears.
Emulation
?PCL 6
Press the or
4
pears.
Emulation
?KC-GL
Press the ENTER key.
5
Emulation
KC-GL
Press the key to move to the >KC-GL > Pen
6
Width sub-menu.
>KC-GL
Pen Width
Press the key.
7
>>Pen(1) Width
01 dot(s)
Press the or
8
pen number of 1 to 8 appears.
When the desired pen number is displayed, press the
9
ENTER key.
To change the pen width, press the
10
press the ENTER key. A blinking cursor (_) appears
at the width value.
>>Pen(1) Width
02 dot(s)
Press the or
pen width in dots (00 to 99) appears. When the
desired pen width is displayed, press the ENTER
key.
key repeatedly until Emulation
key repeatedly until KC-GL ap-
>
>
key repeatedly until the desired
key, then
key repeatedly until the desired
1-25