Usb Interface; Specifications; Interface Signals - Kyocera FS-6020 Operation Manual

Appendix A Host Computer Interface
Strobe* [nStrobe] (Pin 1)
A negative-going Strobe* pulse causes the printer to read and
latch the data on the Data 0 [1] to Data 7 [8] signal lines.
Data 0 [1] to Data 7 [8] (Pins 2 to 9)
These eight signals form the data byte sent from the host
computer to the printer. Data 7 [8] is the most significant bit.
Acknowledge* [nAck] (Pin 10)
This negative-going pulse acknowledges the previous
character received by the printer.
Busy [Busy] (Pin 11)
This signal is high when the printer is busy and low when it
is able to accept more data.
Paper Empty [PError] (Pin 12)
This signal goes high when the printer has received a print
job and run out of paper.
Online [Select] (Pin 13)
This signal is high when the printer is online and low when
the printer is offline. It goes low when the GO key is pressed
to set the printer offline.
+5 V DC (Pin 18)
This line is connected to the printer's +5 V DC line (+5 V ±0.5
V, maximum 400 mA [Serial and Parallel total], fused).
Error* [nFault] (Pin 32)
When the high-speed parallel line control is on, this line
returns error status.
Power Ready (Pin 35)
This signal is high when the printer is turned on.
NOTE
The Paper Empty, Online, and Error signals are not used unless
enabled by the FRPO command (O2 parameter).
A-2

USB Interface

This printer supports the Full-Speed USB 2.0. USB (Univer-
sal Serial Bus) interface specifications and interface signals
are as follows.

Specifications

Basic specification
Complies with the Full-Speed USB 2.0.
Connectors
Printer: B-type receptacle (female) with upstream port
Cable: B-type plug (male)
Cable
Use a shielded cable that complies with USB 2.0 and not
longer than 5 meters (16 feet).
Transfer Mode
Full speed (max. 12 Mbps)
Power Control
Self-power device

Interface Signals

USB Connector Pin Assignment
Pin Signal
1 Vbus
2 D-
3 D+
4 GND
Shell
Description
Power supply (+5 V)
Data transmission
Data transmission
Signal ground
Shield