Kyocera FS-6020 Operation Manual page 55

Press the key. Each time the
6
pressed, the display changes as shown below.
.
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Opt. StatusPage
Off
The following example explains how to activate
7
TCP/IP protocol to connect the printer in the net-
work. You can select Netware or EtherTalk in a
similar manner.
>TCP/IP
On
If TCP/IP is currently Off is displayed, select On
using the or key. Press the ENTER key again.
>TCP/IP
? On
or key is
Range
Set this item to On when
>
you connect to a network
using NetWare. In the sub-
menu (>), frame mode can
be selected from Auto,
Ethernet I I , 802.2, and
802.3 SNAP
Set this item to On when
>
you connect to a Windows
network using TCP/IP.
The sub-menu (>) has
items including DHCP, IP
address, subnet mask
address, and gateway
address. For details on IP
address, see the following
step 8 and subsequent
steps.
EtherTalk must be
activated (On) for
AppleTalk networking
with Macintosh
When the item is set to On,
the printer also prints out
a network status page
when it prints the printer
status page. See Printing
the Option Network
Status Page on page 1-12
>
>TCP/IP
On
Press the
8
pressed, the item changes as shown below.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
Display the item to be set and press the ENTER key.
9
For DHCP, a question mark (?) appears. For IP Ad-
dress, Subnet Mask, and Gateway, the cursor (
blinks.
For DHCP , select On or Off using the
10
For IP Address, Subnet Mask, and Gateway ad-
dresses, press the
(000 to 255) where the cursor is blinking. You can
use the
left.
To obtain these addresses, consult your network
administrator.
.
Press the ENTER key.
11
Press the
12
to
Ready.
>
Chapter 1 Using the Operator Panel
key. Each time the
or key to change the number
and key to move the cursor right and
key. The message display returns
MENU
or key is
)
or key.
1-45