Hard Disk; Memory Card - Kyocera FS-6020 Operation Manual

Chapter 6 Option Units

Hard Disk

Insert the hard disk into its slot on the main circuit board of
the printer. If a hard disk unit is installed in the printer,
received data can be rasterized and stored on this hard disk.
This enables high-speed printing of multiple copies using an
electric sort function. Also, you can use the e-MPS functions.
e-MPS on page 1-35
For details, see
For details of available hard disk, see your dealer.
NOTE
• The hard disk should be installed only by a Kyocera Mita au-
thorized dealer or Kyocera Mita certified technician. Kyocera
Mita shall not be liable for damage due to improper installation
of the hard disk.
• The following instructions are intended for the technician only.
Turn off the printer and disconnect the power cord
1
and printer cable.
Remove the screw from the printer's right side cover
2
and pull the side cover.
Insert the optional hard disk unit into the slot.
3
6-6
.
Replace the right side cover on the printer and
4
tighten the screw to secure the hard disk unit in the
reverse order of removal in step 2 above.
Format the installed hard disk. For details, see
Using the Option Hard Disk on page 1-49

Memory Card

Insert the memory card into the memory card slot located on
the rear side of the printer. A memory card is a microchip
card that may contain option fonts, etc. The printer reads the
contents of the card into its internal memory when the
printer is turned on.
For details of available memory cards, see your dealer.
Turn off the printer.
1
NOTE
Do not insert or remove a memory card while power is
on. If the memory card is removed while the printer is
on, damage could result in the printer's electronics or
the memory card.
Insert the memory card in the slot. Insert it as its
2
surface facing toward the left, connector end first.
Push it in all the way.
Format the installed memory card. For details, see
Using the Memory Card on page 1-46
.
.