Control Module Heat Shield Instruction - Heat & Glo ST-HVBI-AUB Owner's Manual

1.11. Control Module Heat Shield
Installation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation. Sheet metal edges are sharp.
• Remove black sheet metal plate from manual bag. Bend
(3) tabs approximately 90 degrees on plate to form shield
as shown in Figure 41.
Figure 41. Heat Shield Bends
29 Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. Q • 5/15
• Position heat shield in appliance over control module,
being careful not to pinch any wires. The (2) narrow legs
of the heat shield are facing the rear of the appliance.
See Figure 42.
Figure 42. Heat Shield Placement