Deck Fr 2116 Ma; Removing The Mulching Plug - Jonsered FR2111 Operator's Manual

Adjusting the parallelism of the mowing
deck on FR 2116 MA
1. Check that the tyres' air pressure is 60 kPa
(0.6 kp/cm 2 /8.5 PSI).
2. Remove the front cover and the right-hand wing
cover.
3. Loosen the parallelism stay's nuts.
4. Screw out (extend) the stay to raise the rear
edge of the cover. Screw in (shorten) the stay to
lower the rear edge of the cover.
5. Tighten the nuts after adjustment.
6. The parallelism should be checked again after
the adjustment has been made.
7. Fit the right-hand wing cover and the front cover.

Removing the mulching plug

You need to remove the mulching plug, which is
fitted under the cutting unit with three screws, to
change a combi unit from a mulching function to a
cutting unit with rear ejection.
1. Put the cutting unit in the service position, see
"Placing in the service position".
2. Remove the three screws holding the mulching
plug, and remove the plug.
3. Tip: Fit three, full-threaded screws M8x15 mm
in the screw holes to protect the threads.
4. Return the unit to the normal position.
To fit the mulching plug, follow the instructions in
the reverse order.
34
– English
MAINTENANCE FR 2116 MA
6017-155
8009-289