Checking And Adjusting The Brake - Jonsered FR2111 Operator's Manual

Checking the brake FR 2111, FR 2111 M
The brake is a disc brake and is located on the
gearbox.
Check that the brake is adjusted correctly by
measuring the distance between the brake lever
and front edge of the cut-out on the chassis.
The distance should be 0-1 mm (0-0.040") when
the brake is not actuated.
Adjusting the brake FR 2111, FR 2111 M
1. Loosen the locking nuts (1).
2. Tension the wire using the adjuster screw (2) so
that the distance between the brake lever and
cut-out's front edge on the chassis is 1 mm
(0.040").
3. Tighten the locking nuts (1) after adjustment.
Checking and adjusting the parking
brake on FR 2113 and FR 2116
Check that the parking brake is correctly adjusted
by placing the Rider on a slight downhill and
activate the parking brake.
If the Rider does not standstill the parking brake
needs adjusting.
The parking brake is adjusted as follows:
1. Loosen the locking nuts (1).
2. Tension the cable using the adjuster screw (2)
until the play in the cable is taken up.
3. Tighten the locking nuts (1).
4. The parking brake should be checked again
after the adjustment has been made.
WARNING!
A poorly adjusted parking brake
can result in reduced braking
ability.
MAINTENANCE
2
1
1
6008-011
6008-012
6008-239H
25
English –