Mowing Tips - Jonsered FR2111 Operator's Manual

3. Select the required cutting height (1-9) using the
cutting height lever.
In order to obtain an equal cutting height, it is
important that the air pressure is the same in
both front wheels (60 kPa/8.5 PSI).
4. Press in the lock button on the lifting lever and
lower the mowing deck.
IMPORTANT INFORMATION
The life span of the drive belts is in-
creased significantly if the engine runs at
a low speed when the blades are engaged.
Therefore only accelerate once the mow-
ing deck has been lowered into the mow-
ing position.

Mowing tips

• Find and mark out any stones and other fixed
objects to avoid colliding with them.
• Start with a high cutting height and reduce it
until the desired mowing result is obtained.
• The best mowing result is achieved with high
engine revs (the blades rotate quickly) and low
speed (the Rider moves slowly). If the grass is
not too long and thick the driving speed can be
increased without significantly impairing the
mowing result.
Mowing pattern
DRIVING
• The finest lawns are obtained if they are mown
frequently. Mowing will be more even and the
clippings will be more evenly distributed across
the area. The overall mowing time will not be
longer as higher driving speeds can be selected
without impairing the mowing result.
• Avoid mowing wet lawns. The mowing result will
be poorer as the wheels will sink into the soft
lawn.
• Rinse off the underside of the mowing deck after
use with water, do not use a high pressure
washer. Now put the mowing deck in the service
position.
• It is extremely important when the Mulching unit
is used that the intervals between mowing are
not too long.
WARNING!
Clean all stones and other objects
that can be thrown
by the blades from the lawn.
8009-251
8009-250
19
English –