Checking And Adjusting The Steering Wires - Jonsered FR2111 Operator's Manual

Checking and adjusting the steering
wires
The steering is governed by means of wires.
After a period of use these can become stretched,
which means the steering setting may have
changed.
The steering is checked and adjusted as follows:
1. Dismantle the frame plate by removing the bolts
(two on each side).
2. Check the tension of the steering wires by
squeezing them together by the arrows as
illustrated.
It should be possible to squeeze the wires so
that the distance between them is half the size,
without using too much force.
3. If necessary, the wires can be adjusted by
tightening the adjuster nuts on each side of the
steering collar. Do not tension the wires too
much, they should only be tightened against the
steering collar.
Support the wire so it does not twist.
If you only tension one side the steering wheel's
centre position may change.
Check the wire tension as set out in point 2
after you have made the adjustment.
24
– English
MAINTENANCE
8009-267
6008-009
6008-010