Table of Contents
Advertisement
Checking and adjusting the brake on
FR 2213 MA, FR2216 A, FR 2216 A2
Check that the brake is correctly adjusted by placing the
machine on a slight downhill slope with the clutch disengaged
and activating the brake.
When the machine does not stand still, the brake should be
adjusted according to the following.
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1).
4 The brake should be checked again after adjustment
WARNING! A poorly adjusted brake can
!
result in reduced braking ability.
Adjusting the throttle wire
FR 2211R, FR 2211M, FR 2213MA, FR 2216A
The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
Maintenance
3 Pull back the throttle to the full throttle position and check
that the choke is no longer actuated.
FR 2216A2
If adjustment is necessary, adjust the lower wire as follows:
1 Loosen the clamping screw for the cable's outer casing
and move the throttle to the full throttle position.
2 Check that the throttle wire is attached to the correct hole
in the lower lever, see diagram.
3 Pull the throttle wire casing to the far left and tighten the
clamping screw.
Checking and adjusting the choke
wire FR 2216A2
If the engine is producing black smoke or is difficult to start
then the choke wire (upper wire) may be incorrectly adjusted.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Check that the throttle wire is attached to the upper lever,
see diagram.
3 Pull the choke wire casing to the far right and tighten the
clamping screw.
– 23
English
Hide quick links:
Advertisement
Table of Contents
