Checking And Adjusting The Brake - Jonsered FR2115MA Operator's Manual

Checking the brake FR 2111
The brake is a disc brake and is located on the
gearbox.
Check that the brake is adjusted correctly by
measuring the distance between the brake lever
and front edge of the cut-out on the chassis.
The distance should be 0-1 mm (0-0.040") when
the brake is not actuated.
Adjusting the brake FR 2111
1. Loosen the locking nuts (1).
2. Tension the wire using the adjuster screw (2) so
that the distance between the brake lever and
cut-out's front edge on the chassis is 1 mm
(0.040").
3. Tighten the locking nuts (1) after adjustment.
Checking and adjusting the brake on
FR 2113 and FR 2115
Check that the brake is correctly adjusted by
placing the Rider on a slight downhill and activate
the brake.
If the Rider does not standstill the brake needs
adjusting.
The brake is adjusted as follows:
1. Loosen the locking nuts (1).
2. Tension the wire using the adjuster screw (2)
until the play on the wire disappears.
3. Tighten the locking nuts (1).
4. The brake should be checked again after the
adjustment has been made.
WARNING!
A badly adjusted brake can result
in impaired braking capacity.
MAINTENANCE
2
1
1
6008-011
6008-012
6008-239H
25
English –