Checking And Adjusting The Brake; Adjusting The Throttle Wire - Jonsered Frontrider FR2216MA 4X4 Operator's Manual

1 Remove the frame plate by loosening the screws (2) and
lift the frame plate by the rear edge.
2 Check the tension of the steering wires by pushing them
together (at the arrows). It should be possible to push
them together so that the distance between them is half as
much, without using unnecessary force.
3 If necessary, the wires can be adjusted by tightening the
adjuster nuts on each side of the steering collar. Do not
over tighten the cables; they should only be drawn in
towards the steering collar.
Hold the cable, for example using an adjustable wrench, so
that it does not twist. If the adjustment is only made on one
side, the middle position of the steering will be affected.
Check the wire tension on completion of the adjustment as
per item 2.

Checking and adjusting the brake

Check that the parking brake is adjusted correctly by placing
the machine on a slope with the front and rear axles
disengaged.
Apply and lock the parking brake.
When the machine does not stand still, the brake should be
adjusted according to the following.
1 Remove the left-hand wing cover.
22 –
English
Maintenance
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1).
5 The brake should be checked again after adjustment
6 Assemble the left-hand wing cover.
!

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
FR 2216MA 4X4, FR 2216A 4X4
1 Loosen the clamping screw for the cable's outer casing
and move the throttle to the full throttle position.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
WARNING! A poorly adjusted brake can
result in reduced braking ability.