Table of Contents
Advertisement
3.6.4 Clearing data
Memories can be cleared to restore default settings.
1. Open the DOCKSIDE SETUP menu.
2. Rotate the course control knob to select COMPASS TYPE, and then press the course
control knob.
3. Rotate the course control knob to select "OTHER", and then press the course control
knob.
4. Press the TURN/MENU key twice to close the INSTALLATION menu.
5. Press the TURN/MENU key to show the main menu.
6. Rotate the course control knob to select SYSTEM SETUP, and then press the course
control knob.
KEY BEEP:
LOCK: UNLOCK
LANGUAGE:
PANNEL DIMMER:
REMOTE CONTROLLER 1:
REMOTE CONTROLLER 2:
CSE AFTER REMOTE:
NEXT PAGE
PUSH MENU KEY O RETURN
TO PREVIOUS MENU.
7. Rotate the course control knob to select MEMORY CLEAR at the bottom of the second
page, and then press the course control knob to show the option window.
8. Rotate the course control knob to select "ALL CLEAR", "AUTOPILOT CLEAR, "DISPLAY
CLEAR" or "PG-500 CLEAR" as appropriate and then press the course control knob.
ALL CLEAR: Clearing all data of Navpilot and PG-500 connected.
NAVPILOT CLR: Clearing all data of Navpilot.
DISPLAY CLEAR: Clearing data of the display unit of Navpilot.
PG-500 CLEAR: Clearing data of PG-500.
You are asked if you are sure to clear memory.
9. Press the course control knob to clear, or press any key to escape.
When the course control knob is pressed, the equipment restarts automatically.
OFF
ENGLISH
1
NFU
NFU
PRESENT COURSE
Page 1
System setup menu (through the main menu)
ALL CLEAR
NAVPILOT CLR
DISPLAY CLEAR
PG-500 CLEAR
Memory clear option window
PREVIOUS PAGE
PORT 1 FORMAT:
NMEA0183 V1.5
DATA OUT
PORT 2 FORMAT:
NMEA0183 V1.5
DATA OUT
SIMULATION MODE:
OFF
MEMORY CLEAR:
NO
PUSH MENU KEY O RETURN
TO PREVIOUS MENU.
Page 2
3. ADJUSTMENTS
3-25
Hide quick links:
Advertisement
Table of Contents
