Table of Contents
Advertisement
2. WIRING
2.2.4
Connection of Teleflex
When connecting the Teleflex
the following modification.
1. Cut the black jumper at the back of the AR4102/4302.
DO NOT cut the red jumper.
2. Make the cable connection as shown below.
3. Change the position of jumper switch JP-2 from #3-4 to #1-2, referring to the illustration
shown on page 2-4.
4. Set SELECT RRU to "LINEAR SENSOR" on the DOCKSIDE SETUP menu. For further
details, see chapter 3.
Processor unit
2-6
®
linear sensor
®
linear sensor AR4102/AR4302 instead of the FAP-6111, do
TB13
1
2
3
SPU Board
4
(64P1140)
5
For BARE line, wind tape around where shield was removed.
Connection of linear sensor AR4102/AR4302
RED
Linear sensor
WHT
AR4102
BLK
or
AR4302
Hide quick links:
Advertisement
Table of Contents
