Furuno NAVpilot-611 Installation Manual page 8

1. INSTALLATION OF UNITS
Mounting
1. Using the template supplied with the unit open a mounting hole in the installation site.
2. Detach the front panel together with the keypad. Attach sponge (supplied) to rear of the
control unit.
3. Set the control unit to the mounting hole, and fix it with four self-tapping screws (3x20,
supplied).
4. Attach the keypad and the front panel to the display unit.
Keypad
Front panel
How to detach the front panel from the mounting place
To detach the front panel after mounting the unit, use the remover (supplied) as below. Note
that the front panel may be damaged if the following is not done. This method is also
available for the optional surface mounting kit.
1. Set the remover to a notch on the upper side of the unit, and pull the remover to raise
the panel slightly.
2. Similarly use the remover to raise the panel at the lower side.
3. Use your hands to detach the front panel.
1-2
Self-tapping screw
(3x20)
Flush mounting of control unit
Remover
Sponge
Display unit