Table of Contents
Advertisement
3. ADJUSTMENTS
3.6 Other Settings
3.6.1 Setting the remote controller
When connecting the optional remote controller(s), the settings of the remote controller port
and course in the FU or NFU mode are necessary.
Setting remote controller port
Set the type of the remote controller connected to the REMOTE1 and REMOTE 2 ports on
the processor unit.
1. Open the INSTALLATION menu.
2. Rotate the course control knob to select "SYSTEM SETUP".
3. Press the course control knob to show the SYSTEM SETUP menu.
4. Rotate the course control knob to select "REMOTE CONTROLLER 1" or "REMOTE
CONTROLLER 2" from the SYSTEM SETUP menu.
5. Press the course control knob to show the remote controller options window.
6. Rotate the course control knob to select the type of remote controller connected.
NFU: Select for button or lever remote controller connection.
FU: Select for dial remote controller connection.
DODGE: Select for dodge remote controller (FAP-6232) connection.
DISABLE: Disable remote controller operation.
8. Press the course control knob.
3-20
KEY BEEP:
ON
LOCK:
UNLOCK
LANGUAGE:
ENGLISH
PANEL DIMMER:
8
REMOTE CONT 1: NFU
REMOTE CONT 2: NFU
CSE AFTER REMOTE: PRESENT
SIMULATION MODE: OFF
RECEIVE SCREEN SETUP: NO
INCOMING NMEA0183 DATA
KEY MODE: DODGE
PORT1 NAME:
_
NMEA0183 V1.5 DATA OUT
PORT2 NAME:
_
NMEA0183 V1.5 DATA OUT
TEST:
OFF
CLEAR SETUP DATA:
System setup menu
NFU
FU
DODGE
DISABLE
Remote controller 1, 2 options window
NO
Hide quick links:
Advertisement
Table of Contents
