Table of Contents
Advertisement
SAFETY INSTRUCTIONS
WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Use the specified power cable.
Use of other power cable may result in
fire.
Confirm that no one is near the rudder
when bleeding air from oil cylinder.
The rudder may move unexpectedly,
possibly causing bodily injury.
When connecting a geomagnetism
detection type heading sensor,
correct magnetic field deviation.
If an autopilot is used without the compen-
sation, unexpected course change may
occur.
Set REMOTE CONTROLLER 1 and 2 on
SYSTEM SETUP menu properly accord-
ing to remote controller connected.
If not done properly, malfunction may
occur. Especially, take care when
setting the NFU-type remote controller.
CAUTION
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or equipment damage.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Control unit
Processor
unit
Remote
controllers
i
Standard
Steering
compass
compass
0.30 m
0.30 m
0.35 m
0.30 m
0.30 m
0.30 m
Hide quick links:
Advertisement
Table of Contents
