Table of Contents
Advertisement
2. WIRING
2.2
Processor Unit
All cables run into the processor unit from the cable entrance and are connected to the
terminal board inside.
Note: When connecting the FAP-6112 to the processor unit directly, cut off the connector
(MJ-A7SPF) at the end of cable and then do the follows.
2.2.1
How to fix cables to the clamp
Cables are not location-specific so you may fix them on the cable clamp in any order.
1. Unfasten five pan head screws to remove the cover.
2. Unscrew five pan head screws to dismount the clamp stopper.
Clamp stopper
3. Twist cable cores, and then insert them into the cable block as appropriate.
4. For NMEA cable, wind vinyl tape (local supply) around cable cores.
5. Fasten three cable ties to attach a cable to the appropriate leg of the processor unit as
below.
Braided shield
(If your cable doesn't
have braided shield,
wind the copper tape
around alminum foil.)
2-2
Processor unit, clamp stopper
Cable block
Clamp leg
How to fix the cable to clamp leg
Drain wire
Vinyl tape
Cable ties
Cable
Hide quick links:
Advertisement
Table of Contents
