1. From the Operate pull-down menu, SELECT the Shutdown/Restart procedure.
2. On the Shutdown/Restart procedure window, SELECT the Shutdown
3. If necessary, switch power off to the system or the individual printer. See
Restarting the System
Note: In duplex mode, this procedure applies to the complete system (both
1. From the Operate pull-down menu, SELECT Shutdown/Restart.
2. On the Shutdown/Restart procedure window, SELECT the Restart pushbutton.
3. Enable the host attachments, if necessary. See "Enabling and Disabling
4. Try the operation that was in progress when the Restart was requested again.
62
InfoPrint 3000 Operator's Guide
pushbutton.
If you decide that you do not want to shutdown or restart the system, SELECT
the Cancel pushbutton.
If the printers are in duplex mode, or if the printers are in dual simplex mode
and the final simplex printer is being shutdown, the following messages
appear:
v The message Shutdown in Progress appears after you select the Shutdown
pushbutton.
v Shutdown Complete appears when the shutdown process is complete.
"Controlling the System Power" on page 56 for details.
As required, correct the problem that caused you to initiate the procedure.
printers). In dual simplex mode, this procedure applies to the target printer
only.
Attachments" on page 63 for details.