Messages With System Reference Codes; Printer Status Window - Status Field - IBM INFO PRINT 3000 Operator's Manual

Table 29. Printer Status Window - Status Field Messages (continued)
Message
WARMING UP
SLEEPING
NOT AVAILABLE
PRINTING
TRACING
PRE/POSTPROCESSOR BUSY
PRE/POSTPROCESSOR NOT
READY
PRE/POSTPROCESSOR EOF
PRE/POSTPROCESSOR PAUSED
"Blank"

Messages with System Reference Codes

The following table lists all of the messages that include a system reference code.
There are three types of messages included:
Out of Supplies
Intervention Required
Printer Error
Note: All of the messages are Printer Error messages unless noted otherwise. Also,
280
InfoPrint 3000 Operator's Guide
Description
In duplex mode, the fuser in one or both system printers is warming up so that print
jobs can begin.
In simplex mode, the individual printer fuser is warming.
In duplex mode, the Printer Configuration "Fuser Inactivity Timer" in one or both
system printers has timed out and the fuser has been turned off.
In simplex mode, only the fuser in the individual printer has been turned off.
In duplex mode, the Display Touch Screen cannot communicate with either or both of
the system printers.
In simplex mode, the Display Touch Screen cannot communicate with the individual
printer.
In either duplex or simplex modes, when an enabled preprocessing or postprocessing
device has been powered off.
In duplex mode, the system is printing.
In simplex mode, only the individual printer is printing.
In either duplex or simplex modes this indicates that a trace operation is running.
In either duplex or simplex modes this indicates that an enabled preprocessing or
postprocessing device is showing "Busy" status on its interface.
In either duplex or simplex modes this indicates that an enabled preprocessing or
postprocessing device is showing "Not Ready" status on its interface.
In either duplex or simplex modes this indicates that an enabled preprocessing or
postprocessing device is showing "End-of-File" status on its interface.
In either duplex or simplex modes this indicates that an enabled preprocessing or
postprocessing device is showing "Paused" status on its interface.
No secondary status message to display.
The message appears on the Out of Supplies window (see "Out Of
Supplies Messages" on page 276).
The message appears on the Intervention Required window (see
"Intervention Required Messages" on page 277).
The message appears on the Printer Error window (see "Printer Error
Messages" on page 274).
note that all of the following messages appear on the Printer Display Touch
Screen.