Table of Contents
Advertisement
Configure Pull-Down Menu
Figure 12 shows the selections available on the Configure pull-down menu.
Note: If the printer is not stopped, some items are "grayed out."
Figure 12. Configure Pull-Down Menu
Define Forms...
Configure Printer...
Configure Attachments...
Configure Pre/Post...
Adjust Print...
Remote Access...
Operate
Configure
Define Forms...
Configure Printer...
Configure Attachments...
Configure Pre/Post...
Adjust Print...
Remote Access...
Ready
Check Reset
Lets you change, add, and delete form definitions. You must define a form
before you can assign and load it on a printer. See "Defining Forms" on
page 247 for more information.
Lets you display, update, or print out a copy of the printer configuration.
See "Configuring the Printer" on page 219 for more information.
Lets you display, update, or print the configuration settings of all installed
attachments. See "Configuring the Host Attachments" on page 229 for more
information.
Lets you add, delete, or change the specifications of preprocessing or
postprocessing device interfaces. See "Configuring
Preprocessing/Postprocessing Devices/Interfaces" on page 241 for more
information.
Shifts the logical page on a form when you are using preprinted forms or
other forms that require precise alignment. See "Adjusting the Print
Position" on page 68 for more information.
Lets you enable and configure remote access to the printer via Simple
Analyze
Options
NPRO
Help
Cancel Job
47
Chapter 5. Task Summary
Advertisement
Table of Contents
