Procedures For Performing Cutting Using A Computer - Roland EGX-600 User Manual

Roland engraveing machine user's manual
Hide thumbs Also See for EGX-600:
Table of Contents

Advertisement

4-1. Procedures for Performing Cutting Using a Computer

Before you send cutting commands from a computer, you first need to set the cutting parameters. You make the settings
for cutting-in depth, feed rate, spindle speed, and other values to match the cutter and the workpiece. The method you use
to make the settings differs from one program to another.
For more information on how to set the cutting parameters
See p.59 "Setting the Cutting Parameters"
This machine starts operating immediately when it receives commands from a computer. However, you should close the
spindle cover before sending commands. For safety, the machine does not operate while the cover is open.
Chapter 4 - Performing Cutting Using a Computer
58

Advertisement

Table of Contents
loading

This manual is also suitable for:

Egx-400

Table of Contents