Table of Contents
Advertisement
9-6. Specifications
Interface Specifications
Parallel Connector
Standard
Input signal
Output signal
I/O signal level
Transmission method
Serial Connector
Standard
Transmission method
Transmission speed
Parity check
Data bits
Stop bits
Handshake
Expansion Connector 1
+24V
If (max) = 1A
This circuit is activated when the spindle motor is in operation.
Use within the rated range shown above.
Do not apply voltage greater than 24 V to the terminal.
Do not short the terminal to ground.
No responsible is assumed for effects to which any equipment connected to this external output connector is subjected.
Chapter 9 - Appendix
142
In compliance with the specification of Centronics
STROBE (1BIT), DATA (8BIT)
BUSY (1BIT), ACK (1BIT)
TTL level
Asynchronous
RS-232C specification
Asynchronous, duplex data transmission
4800, 9600, 19200, 38400
Odd, Even, None
7 or 8 bits
1 or 2 bits
Hardware or Xon/Xoff
100 / 2W
Terminals
Ic (max) = 150mA
Compatible plug
Use only a triple-contact plug of the size
described above.
Do not use terminal . Use only terminals
and
.
Advertisement
Table of Contents
