Table of Contents
Advertisement
2. Nose-unit Installation and Menu Settings
5
Install the nose unit. Tighten fully, then loosen
two turns.
6
Fully loosen the lock nut.
Be sure to loosen the lock nut.
7
Use the menus to set [AUTO Z CONTROL] to ON.
(1) Press
several times to display the screen shown at right.
(2) Press
to move the blinking cursor to [OTHERS], then press
(3) Press
several times to display the screen shown at right.
(4) Press
to move the blinking cursor to [ON], then press
8
Use the menu to set [REVOLUTION] to ON.
(1) Press
several times to display the screen shown at right.
(2) Press
to move the blinking cursor to [OTHERS], then press
(3) Press
to move the blinking cursor to [ON], then press
9
Press
several times to return to the top screen.
3-2. Cutter Installation Method 1 (With Nose Unit)
I/O
.
TEACHING SELF
AUTO Z CONTROL
.
<ON>
I/O
.
TEACHING SELF
.
<ON>
X
Z
Chapter 3 - Preparations
OTHERS
OFF
OTHERS
REVOLUTION
OFF
0
Y
0
0
8000RPM
39
Advertisement
Table of Contents
