Table of Contents
Advertisement
When using a diamond scraper, cutting-in is shallow.
Go to the [OTHERS] submenu and make sure [AUTO Z CONTROL] is set to [ON], and also make sure that the lock nut has
been loosened.
Try performing cutting a second time. Some materials that have an extremely hard surface (such as materials that have under-
gone surface treatment) may be suited to double cutting.
The X- and Y-axis feed rate is too fast for the workpiece. Try using a slower feed rate.
The cutter is worn. Try replacing the cutter.
The nose scratches the workpiece.
Make sure the lock nut is loosened completely.
The tip of the nose cone is rough or damaged. Try polishing using fine-grained sandpaper or an abrasive agent.
The nose unit is unsuitable for engraving aluminum or brass.
8-1. Problems with Engraving
Chapter 8 - Troubleshooting
125
Advertisement
Table of Contents
