Performing Cutting Or Printing At The Desired Location - Roland CAMM JET CJ-70 User Manual

8
Input the correction value calculated in step (3).
Select the correction value with the
and press the

Performing Cutting or Printing at the Desired Location

The printing or cutting origin point should be set.
1
Install the alignment tool on the cutting carriage.
2
Use the arrow keys to move the tip of the alignment tool. Move the tip of the alignment tool to the point where the
origin is to be set.
3
Press the
The PAUSE LED lights up
To release the origin point that has been set...
• Set a new origin point in a different location.
• Press the SETUP key (making the SETUP LED go out).
key.
key.
The origin point is set.
key,
When an align point has been set, it is
released if the key is pressed.
29