Table of Contents
Advertisement
5-6. Coordinate Systems Used with the Teaching Feature
3
Use
move the X, Y, and Z axes to the location you
want to make the optional origin. Press
This registers a single optional origin. To cancel and re-
turn, press
4
Repeat steps 2 and 3 as to register a second
and third optional origin. When you're done,
press
screen.
I Level and R Level
These are special points used for positioning the Z axis. You use them only with the teaching feature. They are used with
the [MOVE-ZI], [CUT-ZM], and [CUT-ZI] commands. When you use any of these commands, you need to register the
I level and R level in advance.
The I level and the R level both take the Z0 position as their reference point. If the Z0 position changes, the locations of
the I level and R level also change accordingly. Also, selecting an optional origin in a sequence using the [SEL ORG]
command makes the I level and R level change to locations that reference the selected optional origin.
Using these makes it simple to change such things as the distance for operating the Z axis at the highest speed, and lets
you make fine adjustments to perform operations with less wasted effort. This can help make for efficient cutting as a
result.
Registering the I Level and R Level
1
Press
shown at right, then move the blinking cursor
to [TEACHING]. Press
ing cursor to [SETTING], then press
2
Press
shown at right. Move the blinking cursor to ei-
ther [I LEVEL] or [R LEVEL], then use
This value indicates the number of steps above (positive
value) or below (negative value) the Z0 position. As with
coordinate values, one step is 0.01 mm.
3
Press
The I level and R level locations are registered.
Chapter 5 - The Teaching Feature
86
instead of
.
several times to go back to the top
several times to display the screen
. Move the blink-
several times to display the screen
to raise or lower the value.
.
to
X
Z
.
I/O
TEACHING SELF
.
RUN
EDIT
I LEVEL
<
3000
Y
4000
-15
8000RPM
OTHERS
DELETE
SETTING
R LEVEL
0 >
<
0 >
Advertisement
Table of Contents
