Configure and Monitor Via PCs or Terminals
The following describes the details of the setup items.
Destination:
NetMask:
NextHop:
Mtr:
IF:
TYPE:
Protocol:
4-30
It represents "the IP address of the route destination". If "IP
default" appears in the Destination filed, this entry specifies
the "Default Gateway" of the Tainet WANpro 2000.
It represents the IP netmask of the destination IP address.
It represents the IP address of the next router for
transmission of the IP datagram to the destination IP or
subnet.
A metric for this route.
To identify the interface currently available to the Tainet
WANpro 2000.
1: LAN interface.
2: WAN interface
7: Loopback
First character (Status)
U: The route is valid (up) and in use.
D: The route is invalid (down) and has a metric of 16 (RIP
infinity).
Second character (Source)
I: The route is a direct connection.
R: The route was established from RIP information.
S: The route is a static route.
If the route was established from information gained via RIP
then
the following will appear:
RIP-1 for RIP version 1
RIP-2 for RIP version 2