System; Ppp - Tainet WANpro 2000 User Manual

4.4.1. System

This menu allows the administrator to configure the network parameters of
the WANpro 2000 for the LAN interface. These interface parameters should
be properly set before you make any network connections. The following
was shown after the user selects the sub-Menu of the 'System' menu.
Configuration MENU
------------------------------------------------------------------------------------------------
[System] PPP FR RIP Routing_Table Security NAT Filter DHCP
Setup LAN IP, SubNetMask & WAN Protocol
Enter: select ESC: previous menu '<': left '>': right TAB: next item
LAN IP Address
LAN IP NetMask
WAN Protocol
SNMP
DHCP Daemon
Press [SPACE BAR] to Change Value
1. All IP address response is from WANpro 2000 IP address(Local IP).
2. There are the maximum of 300 IP to establish 1500 connection and 200
IP to establish 500 connection an 20 IP to process the maximum of 50
echo request operation at the same time.
Host
Host WANpro 2000
Host
Figure 4.3
Configure and Monitor Via PCs or Terminals
TAINET WANpro 2000
[10.0.0.254
[255.255.255.0 ]

[PPP

[Enable
[Enable
L A N T L A N E X I TVOID
T A I N E T L A N R
W A N p r o 2 0 0 0 R T S C T S
T X D
L I N K R X D E N T E R
C S R
W A N p r o 2 0 0 0 C S T
PPP over
RS-232(Sync/Async)or
V.35 or RS-530/X.21
Example of WANpro 2000 application
]
]
]
]
WANpro 2000
PPP over
RS-232(Sync/Async)or
V.35 or RS-530/X.21
Host
Host
Host
4-7