Configure and Monitor Via PCs or Terminals
4.2 The 'Configuration'
This section describes procedures for configuration and connection of the
Tainet WANpro 2000 to the Internet / Intranet.
1. Initial Setup
The WANpro 2000 features a setup program that can be initiated and
run from an ASCII Terminal or a PCs Terminal Emulator program.
The user needs to make sure that the Terminal Emulator is currently
connected to the RJ-45 Console port on the WANpro 2000 back panel.
2. Connecting to the Terminal
Ø
The RJ-45 console port needs a DB25 adapter to be transferred
into the DB25 connector in order to make connection to the COM
port of the PCs or Terminals.
Ø
Set COM port to work at a baud rate of 19.2 Kbps, N,8,1.
Ø
Switch on the WANpro 2000 and you will see the following
screen.
3. Enter a Password
!!! Welcome to use TAINET WANpro 2000 !!!
Ø
The password could be up to eight digits in length. After key in
your password, the 'Enter' key is required.
Ø
"root" with lower case is the default password for the
administration.
Ø
The default password è
4-4
Please Enter Password :
"root"