Tainet WANpro 2000 User Manual page 40

Configure and Monitor Via PCs or Terminals
4.4.2. PPP
This menu allows the administrator to configure the network parameters of
the WANpro 2000 for the WAN interface about PPP protocol.
interface parameters should be properly set before you make any network
connections. The following was shown after the user selects the sub-menu
of the "PPP" Menu.
Configuration MENU
--------------------------------------------------------------------------------
System [PPP] FR RIP Routing_Table Security NAT Filter DHCP
Setup PPP
Enter: select ESC: previous menu '<': left '>': right TAB: next item
PPP Local IP Address
PPP IP NetMask
PPP Remote IP Address
PPP Port Speed
NAT
Filter
PPP
Local
IP Address:
PPP
IP NetMask:
PPP
Remote
IP Address:
PPP
Port Speed
NAT
Filter
4-10
TAINET WANpro 2000
[192.72.200.100 ]
[255.255.255.255 ]
[192.72.200.200 ]
[Sync-External
[Disable
[Disable
This parameter identifies the IP address for local WAN port
when the WAN protocol is selected PPP.
WAN port IP netmask when the WAN protocol is selected
PPP.
This parameter identifies the IP address for the WAN port on
a remote router when the WAN protocol is selected PPP.
Select data speed & format when the WAN Protocol is
Selected PPP.
Network Address translation Enable or Disable when the
WAN protocol is selected PPP.
IP Filter Enable or Disable when the WAN protocol is
selected PPP.
]
]
]
These