Table of Contents
Advertisement
The following describes the details of the setup items.
Default Lease Time:
This option specifies the IP address lease time for clients.
It is a time in seconds and the default value is 86400 (1 day).
Gateway:
This option specifies the IP address for router on the client's subnet.
The default value is the LAN IP address of this device.
DNS Server:
This option specifies the IP address for Domain Name System name
server available to the client
WINS Server:
This option specifies the IP address for NetBIOS Name Server
(NBNS) available to the client.
#Note that there isn't any configurations about Netmask. Don't worry about it
because DHCP daemon will get Netmask value from LAN configuration and
pass it to clients.
Items listed below are parameters for Dynamic Leases:
Range from:
Available IP addresses for DHCP clients start here.
to:
Available IP addresses for DHCP clients end here.
Items listed below are parameters for Fixed Leases:
IP Address:
Ethernet Address:
#The IP address must not appear in the IP address range of dynamic leases, or
there will be an IP conflict.
As mentioned in chapter 3, the configuration could be setup via LCD Front
Panel. In this section, the configuration could be setup via PCs or Terminals. To
configure the WANpro 2000, the user could select option one – 'System' and the
pop-up menu will come up after the selection.
Configure and Monitor Via PCs or Terminals
IP address for the client with fixed IP address.
Ethernet address of the client.
4-27
Advertisement
Table of Contents
