Tainet WANpro 2000 User Manual page 30

Configure and Monitor Via Front Panel
E. Routing Table
Default
Gateway
F. Device Control
Warm
Start
Restore
Default
G. Monitor
LAN Rx
Packets
LAN Tx
Packets
LAN Rx
Errors
WAN Rx
Packets
WAN Tx
Packets
WAN Rx
Errors
Each sub-menu contains the individual selectable items. Some of
the sub-menu trees might be changed and come after later version.
User could download the updated software through Tainet's
Internet Web site.
3-8
If the WANpro 2000 receives a packet for an "unknown"
destination (i.e. a packet with an IP address is not listed
in the routing table), it forwards that packet to the Default
Gateway if one has been defined.
Press the " ENTER" key to restart the device.
Press the " ENTER" key to reset the parameters to the
factory defaults.
The total number of input packets received from the LAN
interface.
The total number of packets sent to the LAN interface.
The total number of input packets received from the LAN
interface with specific errors (CRC error, frame error,
missed packet, unknown or unsupported protocol, etc).
The total number of input packets received from the WAN
interface.
The total number of packets sent to the WAN interface.
The total number of input packets received from the WAN
interface with specific errors (CRC error, frame error,
missed packet, unknown or unsupported protocol, etc).
Only the registered user could have the right
to download the software.
End of the Chapter