Cisco 7962G Administration Manual page 78

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option Description
PC Port Speed and duplex of the access port
Configuration (labeled 10/100 PC on the Cisco Unified
IP Phone 7962G and 7942G). Valid values:
• Auto Negotiate
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to auto-negotiate.
If you change the setting of this option, you
should change the SW Port Configuration
option to the same setting. This ensures that
the PC receives the full benefits of the
network operating speed.
PC VLAN Allows the phone to interoperate with
third-party switches that do not support a
voice VLAN.
The Admin VLAN ID option must be set
before using this option.
Related Topics
•
•
•
•
•
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
4-10
Displaying a Configuration Menu, page 4-2
Unlocking and Locking Options, page 4-3
Editing Values, page 4-3
Overview of Options Configurable from a Phone, page 4-4
Device Configuration Menu, page 4-11
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Unlock network configuration
1.
options.
Scroll to the PC Port
2.
Configuration option and then
press the Edit softkey.
3. Scroll to the setting that you
want and then press the Select
softkey.
Press the Save softkey.
4.
Unlock network configuration
1.
options.
Make sure the Admin VLAN ID
2.
is set (see Admin VLAN ID
above in this table).
3. Scroll to the PC VLAN option,
press the Edit softkey, and then
enter a new PC VLAN setting.
Press the Validate softkey and
4.
then press the Save softkey.
OL-12641-01