Sip Configuration Menu (Sip Phones Only); Sip General Configuration Menu - Cisco 7962G Administration Manual

Device Configuration Menu
•
•
•
•

SIP Configuration Menu (SIP Phones Only)

The SIP Configuration menu contains these sub-menus:
•
•

SIP General Configuration Menu

The SIP General Configuration menu displays information about the configurable SIP parameters on the
phone.
Table 4-3 SIP General Configuration Menu Options
Option Description
Preferred CODEC Displays the CODEC to use when a call is
initiated. This value will always be set to none.
Out of Band DTMF Displays the configuration of the out-of-band
signaling (for tone detection on the IP side of a
gateway). The Cisco Unified SIP IP phone
supports out-of-band signaling using the AVT
tone method. This value will always be set to
avt.
Register with Proxy Displays if the phone must register with a proxy
server during initialization. This value will
always be set to true.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
4-12
SRST designation—Indicates a Survivable Remote Site Telephony router capable of providing
Cisco Unified Communications Manager functionality with a limited feature set. This router
assumes control of call processing if all other Cisco Unified Communications Manager servers
become unreachable. The SRST Cisco Unified Communications Manager always appears last in the
list of servers, even if it is active.
You configure an SRST router address in the Cisco Unified Communications Manager
Administration SRST Reference Configuration page (choose System > SRST). You configure an
SRST reference in the Device Pool Configuration page (choose System > Device Pool).
TFTP designation—Indicates that the phone was unable to register with a Cisco Unified
Communications Manager listed in its configuration file and it registered with the TFTP server
instead.
Authentication icon—Appears as a shield
Cisco Unified Communications Manager is authenticated. For more information about
authentication, refer to Cisco Unified Communications Manager Security Guide.
Encrypted icon—Appears as a padlock
Cisco Unified Communications Manager is authenticated and encrypted. For more information
about authentication and encryption, refer to Cisco Unified Communications Manager Security
Guide.
SIP General Configuration Menu, page 4-12
Line Settings Menu, page 4-14
Table 4-3 describes the options in this menu.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
and indicates that the connection to the
and indicates that the connection to the
To Change
Display only—cannot
configure.
Display only—cannot
configure.
Display only—cannot
configure.
OL-12641-01