AMT Datasouth ACCEL-6300 User Manual page 204

Function
Ignore ........................................
Continue printing? ....................
Bell .............................................
Backspace ..................................
Horizontal tab ...........................
Line feed ....................................
Vertical tab ...............................
Form feed ..................................
Carriage return .....................
Start double-wide print- ..........
ing for one line
Table D-5. Epson and IBM Control Codes
ASCII Hexadecimal
NUL 00 or 80
ENQ 05 or 85
BEL 07 or 87
BS 08 or 88
HT 09 or 89
LF 0A or 8A
VT 0B or 8B
FF 0C or 8C
CR 0D or 8D
SO 0E or 8E
Decimal
0 or 128 The printer ignores this code unless it is used within an
escape sequence.
5 or 133 With the ENQ/ACK serial handshake in use, this code
causes the printer to return an ACK control code when it
can receive more data.
7 or 135 This code sounds the audible alarm for a brief period.
8 or 136 This code moves the current print position one character
space to the left. If the current print position is the left-
most, the printer ignores this code.
9 or 137 This code moves the current print position right to the next
horizontal tab stop on the current line. If no tab stop is set
to the right of the current print position or the next tab stop
on the line is beyond the right margin, the printer ignores
the code. If the factory defaults are in effect, tab stops are
set every eight print positions across the page.
10 or 138 This code advances the paper one line space. If the current
line position is the last printable line on the page, the printer
performs a form feed instead of a line feed. If the automatic
carriage return mode is on, the printer performs a carriage
return in addition to the line feed.
11 or 139 This code advances the paper to the next vertical tab stop.
If no vertical tab stop is set below the current line position
on the page, the printer ejects the page and advances to the
first line on the next page. If no vertical tab stops are set,
the printer performs a carriage return and line feed.
12 or 140 This code ejects a cut sheet or advances pin-feed paper to
the next top-of-form or top margin if one is set. This code
also moves the current print position to the left margin.
13 or 141 This code moves the current print position to the left mar-
gin. If automatic line feeding is active, the printer performs
a line feed in addition to the carriage return.
14 or 142 This code starts double-wide printing on the current line
and doubles the character spacing to accommodate the
wider characters. A DC4 code or any control code or escape
sequence that causes paper movement ends double-wide
printing and resumes normal character spacing. The Start/
End Double-Wide Printing sequence also ends double-
wide printing.
User's Guide
Description
Code Sets D-25