AMT Datasouth ACCEL-6300 User Manual page 158

Table A-1. Troubleshooting the Bottom-Feed Tractors––continued
Symptom
Printer does not present form
for tear-off when you press
Ready button.
Print is smearing.
Printing occurs on paper tear
strips.
Probable Cause/Corrective Action
Demand document mode is not
selected or is set incorrectly.
Check DEMAND parameter
setting on Setup menu.
Paper is not snug between
tractors. Adjust tractors.
Printhead is too close to platen.
Make sure PH GAP and
PFORCE parameters on
Setup menu are set to Auto.
Paper is misaligned in the
printer. Refer to Loading
Paper in the Bottom-Feed
Tractors in this appendix.
Paper is too narrow. Use
paper that is at least 4.5 inches
(11.4 cm) wide including the
perforated tear strips.
Bottom-Feed Tractors A-7
User's Guide